# Vape pen batteries, built-in cell or removable battery

> A vape pen read from its battery, built-in or a removable 18650 or 21700 cell, energy in watt-hours, the amps drawn and the UK 2 ml tank limit.


On shop shelves, the **vape pen** sits under a single label, yet two devices of the same diameter can hide very different power sources. One keeps its battery sealed inside the body. The other opens onto a bay where you slide in a cell of your own choosing. Listings quote milliamp-hours and watts without ever linking the two. Here, hardware is read from its cell, and the pen-style tube is no exception.

## Vape pen batteries, two families

A **vape pen** runs either on a built-in battery, charged by cable and never replaced, or on a removable 18650 or 21700 cell that you take out to swap. The first family aims for simplicity and moderate output. The second holds more energy and reaches higher wattages, provided the cell you choose can supply the current asked of it.

Two 25 mm tubes show the gap. The Innokin EZ Tube carries a built-in 2100 mAh battery, while the Eleaf iJust 21700 takes an interchangeable 21700 or 18650 cell.

Unless stated otherwise, their specifications come from the manufacturers' own pages. The currents and times given below are calculations, not measurements.

## A tube's diameter often gives its battery away

A battery's name gives its size. An 18650 is 18 mm across and 65 mm long, a 21700 is 21 mm across and 70 mm long. Those figures set a physical limit on what a cylindrical body can hold.

### Slim pens and their built-in batteries

A tube slimmer than 21 mm cannot take a 21700. On these slim cylindrical e-cigarettes, the battery is built in for all practical purposes, and its reserve is read in mAh on the listing, with no cell to choose.

### At 25 mm, both approaches exist side by side

Innokin lists the EZ Tube at 25 mm across and 90 mm long without its tank. Eleaf gives the iJust 21700 the same 25 mm diameter, a height of 97 mm and a weight of 55 g without a cell.

At the same size, the diameter no longer settles the question. The listing has to say whether the battery is "built-in" or the cell is "changeable", and that is the line to look for before anything else.

## Vape pen battery life, counting in watt-hours rather than mAh

Capacity in mAh only tells part of the story. The energy actually stored is counted in watt-hours, by multiplying the capacity by the cell's nominal voltage, and that is the figure that lets you compare two vape pens.

Molicel publishes for its INR-21700-P45B cell a nominal voltage of 3.6 V and a typical capacity of 4.5 Ah, which makes 16.2 Wh. Innokin gives 2100 mAh for the EZ Tube without stating a voltage. This guide therefore makes an assumption, the usual 3.6 V of a lithium-ion cell, which puts the reserve at about 7.6 Wh (2.1 x 3.6).

Those watt-hours are spread over cumulative firing time, meaning the total number of seconds during which the coil heats. The table divides the energy by the output, before the chipset's conversion losses.

| Device and power source | Energy | At 15 W | At 40 W | At 80 W |
| --- | --- | --- | --- | --- |
| EZ Tube, built-in 2100 mAh | about 7.6 Wh (assuming 3.6 V) | 30 min | 11 min | out of range |
| iJust 21700 with a P45B | 16.2 Wh | 65 min | 24 min | 12 min |

At equal output, the removable cell roughly doubles the reserve. Doubling the wattage, on the other hand, halves it, whichever family you pick. Our guide to [vape battery life](/uk/vape-battery-life/) runs the same sum for other set-ups.

## The amps a pen-style device asks of its cell

On a regulated device, the displayed wattage divided by the cell voltage sets the current drawn, before the chipset's losses push it up slightly. The coil only matters through the wattage range it imposes, which makes the sum possible before you even buy.

| Set-up | Output used | Current at 3.6 V | Current at 3.2 V |
| --- | --- | --- | --- |
| EZ Tube, Z-Coil 0.8 ohm (15 to 18 W) | 18 W | 5 A | 5.6 A |
| EZ Tube, Z-Coil 0.3 ohm (30 to 40 W) | 40 W | 11.1 A | 12.5 A |
| iJust 21700, maximum output | 80 W | 22.2 A | 25 A |

The 3.2 V column describes a cell near the end of its charge, when it has to deliver more amps to hold the same wattage. The full reasoning sits in our guide to [vape wattage from the battery side](/uk/vape-wattage-and-batteries/).

On the EZ Tube, that current is Innokin's business, since the brand sized its battery for a 6 to 40 W range. On the iJust 21700, you supply the cell, so it falls to you to check that it can hold 25 A near the end of the charge at full output.

## Removable-battery pens, choosing the cell

A vape pen with a removable battery opens up the choice of cell, and that choice rests on a figure the wrap rarely puts forward. Two checks are enough, one on the cell maker's datasheet and one by eye.

### Discharge rating before capacity

The capacity printed large on the wrap does not tell you whether the cell can keep up. The figure that counts is the discharge current published by its maker. For the P45B, Molicel states 45 A, a comfortable margin over the 25 A worked out for 80 W near the end of the charge.

An 18650 also fits the iJust 21700, according to Eleaf. Being smaller, it stores less energy, and its discharge rating varies widely between models. Our comparison of [21700 vs 18650 batteries](/uk/21700-vs-18650-batteries/) explains what those millimetres change.

### The wrap, checked at every insertion

A split wrap or a damaged insulator ring around the positive terminal is enough to set a cell aside, whatever its discharge rating. The check takes place each time the cell goes back into the tube.

A cell taken out of the device goes into a case, never loose in a pocket with keys or coins. Our [vape battery charger guide](/uk/vape-battery-charger-guide/) covers what to look for when charging a cell outside the device.

## Built-in battery pens, reading the light and charging

With no cell to remove, a built-in battery is monitored through its indicator light and charged through the device's own port. Indicator thresholds vary from one model to the next, and only the maker's page gives them.

Innokin describes for the EZ Tube a red light below 10% charge, yellow between 10 and 30% and green above 30%. Green therefore covers more than two thirds of the reserve on its own, and the switch to yellow means less than a third is left.

Charging runs on direct current, at 5 V and 1.5 A according to the manufacturer, which does not publish a charging time. This guide gives none either. At Eleaf, the iJust 21700 shows its level through a four-colour light.

The built-in cell cannot be changed. Once it no longer holds its charge, the body of the device is at fault, and no spare part replaces it.

## Vape pen tanks and the UK 2 ml limit

Both families meet at the tank. Innokin lists 4 ml for the EZ Tube and 2 ml in its TPD version, while Eleaf sells the iJust 21700's Ello Duro in 5.5 ml or 2 ml.

UK rules cap refillable tanks at 2 ml, so a UK listing should show the 2 ml version, whatever battery the device uses. On the same rules, nicotine e-liquid is limited to 20 mg/ml and sold in bottles of no more than 10 ml.

## FAQ

Five practical questions about pen-style devices that product listings often leave unanswered.

### Which vape pen family suits a beginner?

No single model wins outright, but the built-in battery family asks for less know-how, since the manufacturer has chosen the cell and its circuit. A removable-battery device means reading a discharge rating, checking a wrap and charging a cell properly.

### How do you adjust the power on a pen with no screen?

On the EZ Tube, output from 6 to 40 W is set by twisting the device, according to Innokin, and the range printed on the fitted coil shows where to stop. Other pens run at a fixed output and have no adjustment at all.

### Can an 18650 go into a device built for a 21700?

Only if the manufacturer says so. Eleaf states that the iJust 21700 works with a 21700 or an 18650, without saying whether an adaptor is included, which is worth checking when the box is opened. Outside that case, a cell smaller than its bay does not belong there.

### Does a removable-battery pen charge without an external charger?

Often, yes. The iJust 21700 has a side charging port, and Eleaf puts a USB cable in the box. An external charger still earns its place for rotating two cells or checking the voltage of a battery that no longer charges back up.

### Is a 21700 device heavier than a built-in battery pen?

Eleaf lists 55 g for the iJust 21700 alone and 107 g for the kit with a 2 ml tank, with no cell counted in either figure. The weight of the cell comes on top. A built-in battery listing gives an all-in weight instead, which skews any comparison between pages.

## Vape pen choice starts with the power source

Two 25 mm devices can therefore hold reserves where one is roughly twice the other, about 7.6 Wh for a built-in 2100 mAh battery assuming 3.6 V against 16.2 Wh for a 4.5 Ah 21700. The first spares you any choice of cell, the second asks you to check a discharge rating and the state of a wrap.

Before colour or airflow, a **vape pen** is chosen on the line of its listing that describes the battery. Reading a device through its cell then opens onto vape hardware as a whole, and it is the thread this site follows.

<em>Editorial content for adult readers only. Vaping products can contain nicotine, which is a highly addictive substance. Vaping products are not for sale to anyone under 18 in the UK. This article is not a buying recommendation.</em>
